Sage v24 not installing on 2008 r1

error installing ODBC driver: Sage Line 50 v24, ODBC error 13: Could not load the setup or translator library. Verify that the file Sage Line 50 v24 exists and that you can
access it.

Sage support little help…. refer to various MS documents then tell you to uninstall and reinstall .net and make a bunch of regedits that make no difference.

After poking through the MSI, the problem seems to be in in the installation of the visual C++ 2015 redistributable, it references files that aren’t there. This gets installed by sage as a prerequisite, but either it doesn’t report it’s failed, or Sage doesn’t check to see if it’s failed.

Try uninstalling/reinstalling it. It’s should be in install\redist\vc_redist.2015.x86.exe of the extracted download.

If it hangs at something resembling windowsvista.msu, run a clean boot (start>run>msconfig, turn off all non ms services & startup), & uninstall/reinstall.

Once that’s done & reinstalled successfully the ODBC/data components should install OK

Leave a Reply

Your email address will not be published. Required fields are marked *